Rimage EVEREST Guide de l'utilisateur télécharger pdf (Page 30)

Rimage Everest Printer

24 110632_L

Cleaning the Everest printer

Clean the print head

Before you begin:

Power off the printer.

1. Access the print head.

a. Press the two cover latches to release the side cover.

b. Lower the side cover.

c. Open latch 1.

d. Remove the print ribbon carrier. For specific instructions, refer to page

20.

2. Clean the print head.

p Caution! Wipe the print head from

one end to the other. Do not stop

wiping in the middle of the print

head.

p Caution! Do not scratch the print

head. The white area in the picture

shows the area to clean.

a. Apply isopropyl alcohol to the sponge swab.

b. Use the sponge swab to wipe across the print head from one end to the other.

c. Repeat as needed until the print head is clean of dust and debris.

d. Use the sponge swab to remove any waxy buildup from the roller below the print head.

Latch 1

Printhead

Wipe

direction

3. Prepare the printer for use.

a. Install the print ribbon carrier.

b. Close all latches.

c. Close the side cover.

d. Power on the printer. The printer is ready.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 233 234

Pas de commentaire

Rimage EVEREST Guide de l'utilisateur Page 30